LASOX-COAT®: Novel method for the selective oxidation of aluminium surfaces prior to serial production

With this process components can be protected selectively against wear and corrosion. A pilot plant is located in the French subsidiary Faulquemont. Now, the process is ready for serial production.

The so called LASOX-COAT^® treatment by AHC Oberflächentechnik is used for the selective coating of aluminium surfaces via laser. While the workpiece is under an oxygen atmosphere, the laser is targeted along the surface to be coated. The laser starts to melt the alloy and some particles will vaporize. Together with the oxygen this leads to the formation of an oxygen plasma. The oxygen plasma - which consists of ionized atoms - and the molten aluminium react to aluminium oxide which now covers the treated surface. The thickness of this corundum layer is typical around 6 to 10 µm, while the remolten area is about 100 µm thick. The hardness of the aluminium oxide is approx. 2,000 HV. The hardness of the remolten zone depends on the used alloy, and with Si-containing alloys (Si>8%) the hardness can increase by 50% relative to the original alloy.

The major advantage of this process in contrast to galvanic processes lies in the complete abandonment of chemicals. Also no pores are formed in the aluminium oxide layer which explains the increased hardness. Pores in the basic material will affect the layer growth negatively. Silicon helps to grow a thicker but slightly rougher layer and even alloys with more than 20% silicon can be coated with LASOX-COAT^®. The possibilities of the selective coating are plenty, like writings, single lines, complex forms or patterns. While flat surfaces are preferred, round surfaces are also possible. An integration of LASOX-COAT^® into existing production lines is also planned. LASOX-COAT^® is best for wear protection but can also be used to reduce corrosion on the workpiece.